Hello Dear Reader
Today In this Post we are Going to Explain What is 10.0.0.0.1 & How it’s Used. Also What is the Confusion Between 10.0.0.1 & 10.0.0.0.1
You See We Understand that If You Are able to Login to Your Router Admin Panel it allows you to make certain changes As You wish Like –
- Range Extender Setup, Password Recovery Or Lookup
- Security & Troubleshooting of Router Performance
- Checkup on firmware, Speed & consumption & much More
Let’s Dive into the Guide to Get You Information –
In Our Quest of Helping People to Learn & Practically Understand all About Default IP addresses & default Credentials, We Have Never Seen Something As Funny as this Topic. Give us a Minute & read till last to Learn the Real & Funny side of this 10.0.0.0.1 Ip Address.
Before we start let us assure you that we will Make sure that at the last of this Topic you will be able to get desired Results With Correct Guidance On How to access the Router Dashboard Console With Default Router Ip.
What is So Funny
Every Month Half of the Million Users search this Ip Address Only to End Up Reading Some Helping Blog Like this For Guidance. The funny part is There is No Working Ip Ip Such as 10.0.0.0.1 as of Now Being Used as Default Gateway. This is a Wrong Ip address However It’s Quite Possible That You were Trying to access the 10.0.0.1 Ip Address.
Difference Between 10.0.0.1 & 10.0.0.0.1
10.0.0.0.1 Ip contains an extra Zero (0) & that’s Makes it Not Accessible Because IPv4 Ip Address Contain Only Four-Number Ip. As of Now Router Maker Brands & Internet Service Providers Corporations such as Xfinity/Comcast are Only Using Ip Address Like 10.0.0.1 Xfinity/Comcast Login, 192.168.0.1, 192.168.1.254, etc as Their default Ip Address.
We Hope this Concludes that 10.0.0.1 is the Correct Ip Address for So Try The Ip to log in to the Router. Also if this Ip Doesn’t Work & if you Are Looking to log in to Xfinity/Comcast Router Weight Suggest You Try 192.168.1.1 or 192.168.1.100
Looking For Xfinity/Comcast Router Login
if you have a modem and router where you want to login the router admin page please use the 10.0.0.1 IP address instead of the 10.0.0.0.1
- you can always use ipconfig command to find out the default IP address for the router before proceeding.
- once you have the ip address open the browser and type the default ip address on the top of the browser and press enter.
- you may see the router/modem admin page now asking for username and password.
- use the default username and password to access the settings.
do check out the Xfinity article related to the topic check out https://www.xfinity.com/support/articles/wifi-change-admin-tool
Let’s See if this Helps you Get the Work Done as you wanted However you can always leave a Comment Behind for Help & Suggestions. we Read All comments & reply if Any Help is Needed. It Was Fun Writing this Post. Thanks for Reading